Application Instructions ♡
Follow the directions below for the best application of your new snowboard wrap. Everything needed is included in our Application kit, available for purchase here.
1. Remove bindings and stomp pad. Make sure to note your binding placement and which way you face on your board (regular or goofy).
2. Using Goo-Gone or the adhesive removal pad included in our application kit, remove any adhesive residue.
Using isopropyl alcohol, or the alcohol pads in our kit, wipe down the entire top surface of the board. Any dirt or sticker residue may cause the wrap to lay down unevenly or cause air bubbles. Your board should feel smooth to the touch. The cleaner the board, the better your wrap will look.
3. Align your PVC wrap (backing still on) with your board facing the right way. Make sure to leave 1 inch of wrap on the edges to ensure full coverage. If you want to include more of one side of the wrap, simply shift the alignment.
Remove the wrap backing. Starting at the top, peel the backing and roll it underneath the wrap. Gently pulling it down
4. Using a flat edge, or the felt edge applicator provided in our application kit, start at the center, and scrape downwards and to the edges of the board. This step is important to do as the wrap is laid down so air bubbles can be prevented. Continue slowly peeling the backing and apply pressure the vinyl. Make sure to continue scraping towards the edges. If an air bubble appears, carefully peel the wrap back up and reapply. Once the wrap has been completely laid down, flatten the entire board and edges.
5. Remove the top protective film. After the wrap has been fully laid down, starting at the corner, carefully peel back the thin protective film to reveal the gloss.
6. Trimming the edge. Using the blade provided in our kit or your own sharp Exacto knife, press it against the side of the board at a slight angle. Carefully and slowly begin trimming the excess wrap, following the contour of the board. It is important to go slow for this step to prevent too much wrap from being cut off.
6. After the excess wrap has been fully removed, squeegee around the whole edge of the board to ensure your new wrap is fully applied.
7. Bindings. The outline of where to place the bindings should be faintly visible through the wrap. Poke holes with the screw driver in the correct placement, and screw your bindings back on the board.
8. Stomp pads are recommended to be placed towards the midline of the board. Skate rails, or stomp pads placed on the edges pose the risk of causing the wrap to lift. Place with caution.
Your new board is ready to ride! ♡